Home/Support/Support Forum/xbee pro s2c modules are not joining nrf52840 coordinator network

xbee pro s2c modules are not joining nrf52840 coordinator network

0 votes
xbee pro s2c modules acting as router and end device are not joining nrf52840 acting as coordinator in network . Xctu showing channel 0 for xbee routers.
asked Mar 19 in ZigBee PRO Featureset (and legacy ZNet 2.5) by devAtMikroStarTech New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Dev,

First, you are going to need to determine which Zigbee/802.15.4 Protocol and Profile the NRF 52840 is implementing in its code. Once you know that, you can adjust the XBee modules settings as needed. For example, the ZS parameter will likely need to be adjusted to either a value of 1 or 2. Other settings such as EE and KY may need to be adjust depending on which Profile is being used.

Digi Support
answered Mar 19 by mvut Veteran of the Digi Community (11,963 points)
...