Home/Support/Support Forum/Could not find any device - Error reading hardware version

Could not find any device - Error reading hardware version

0 votes
Hello,

I have used the XCTU app and dev board successfully several times to run AT commands and microPython scripts but since yesterday I got this error message when I try to connect the device :

"Could not find any device in port usbserial-XXX > Error initializing XBee device parameters > Error reading the hardware version"

I have tried the recovery option without success.

I got the same error with 1 Xbee and 1 Xbee3 devices.

Any idea ?

Matthieu
asked Feb 18 in XBee Cellular by matthieugd New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Matthie,

What interface board are you using? Are you powering it externally?

What happens if use the XBee recovery function?

What happens if you try to enter the bootloader manually via the DTR line being held low and triggering a reset with the Break enabled?

Eric
Digi Support
answered Feb 18 by mvut Veteran of the Digi Community (13,094 points)
Ok, instead of using the "Add device" option, if I use the "Discover device(s)", it's working.
Thank you.

1) XBIB-U-DEV and yes it's powered externally
2) The recovery function completes but I got the same error after I try to connect again (I also tried the recovery mode with the cellular modem flashing option )
3) I'm not sure how do that, do you have any documentation that shows the procedure?
Matthie,

That is because the baud rate that the radio is actually configured for is different than the rate you told XCTU to look for the radio at.  That is why the Auto search function worked.

Eric
Digi Support
0 votes
Check each of your statements!
answered Feb 21 by moitruonghopnhat New to the Community (1 point)
...