Home/Support/Support Forum/Can I use one of the Xbee3 DIO pins to output a string

Can I use one of the Xbee3 DIO pins to output a string

0 votes
I am reading values from an accelerometer, and storing these into a variable in java. Can i then output these through one of the DIO pins on the xbee grove board to a MSP430 or can ints that are sent wirelessly only be accessed serially.
asked Nov 22, 2019 in Miscellaneous Hardware and Software by TrentJ New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The DIO function of the XBee products is for triggering a Digital line either as an output high or low state. So I would not think of it as being used to send value data. I would expect you to use the UART if you want to send Ascii or Hex data to a device.
answered Nov 22, 2019 by mvut Veteran of the Digi Community (13,472 points)
...