Home/Support/Support Forum/Connectport TS 16 MEI cold Standby setup
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Connectport TS 16 MEI cold Standby setup

0 votes
Scenario:
2x ConnectPort TS 16 MEI > both with same configuration and same IP-Address
1x Windows Server 2016
1x RHEL 7.6 1.9.37-3

PortServer 1 is connected to the LAN and Power on
PortServer 2 is not connected to the LAN and Power on

Windows Server 2016 can open Serial Interfaces on the Portserver. (ok)
RHEL 7.6 can open Serial Interfaces on the Portserver. (ok)

for a redundancy test we disconnect the LAN cable on Portserver 1 and plugged in on Portserver 2.

Same test:

Windows Server 2016 can open Serial Interfaces on the Portserver. (ok)
RHEL 7.6 cannot open Serial Interfaces on the Portserver. (nok)
we need to reinitialize the Portserver (./dgrp_cfg_node init <identifier> <IP Adress> <Number of Ports>) then it is (ok)

when we change the 2 ConnectPort TS 16 MEI to 2 older Models (ConnectPort TS 16)
then Windows and RHEL works fine (ok) without reinitialize.

is there an fix available?

Regards Peter
asked Nov 14 in ConnectPort TS by pdm New to the Community (0 points)

Please log in or register to answer this question.

...