Home/Support/Support Forum/SPI pins on Xbee 3.0 MMT don't let me blink a led

SPI pins on Xbee 3.0 MMT don't let me blink a led

0 votes
Hello, i working with a Digi Xbee 3.0 MMT device and i just had a trouble with communication and consist on the following:
1) the host Xbee attach to mi PC discover the remote one, and can read all of their configuration
2) i can write some parametters like Baud rate (BD),MicroPython Auto start (), D0, D1, D2, D3, D4, D5.
3) But other parametters like D8 NA[2], and SPI interface don't let change the default Option[1]
the error message said:
"Error writing the following AT parameters
-P5: Invalid parameter"

And so on with P5,P6 P7 P8 and P9 pins

4) i Previously tried a MicroPython script on the host xbee with each of the SPI Pins and it worked fine, but i flash this same script on the xbee remote's file system and don't work.
the configuration on each xbee (host and remote )are the same:

Product Family: XB3-24.
Function Set: Digi Xbee Zigbee 3.0.
Firmware Version: 1007.

Thanks in advance.
Link to the video where you see what I just described
asked Sep 25, 2019 in XBee3 ZigBee by william.galvis New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi! I got exactly the same problem, after firmware update my uart get disabled and the spi is enabled by default. I cant switch to the uart again with the same error.
answered Jul 9 by maxim_dorogov New to the Community (2 points)