Home/Support/Support Forum/Xbee api receive sensor data

Xbee api receive sensor data

0 votes
Hy everyone,
I have 2 xbee router AT, where they´re coupled to water sensors. The water sensor is connected to the pin3 of xbee (data in) and it sends pulses to the coordinator, that´s in API mode. If I turn on only one node talking to my coordinator, I can see the packets coming in the XCTU (received packet) and with an arduino coupled to the coordinator, I can read the received api frame (that arrives only when the water sensor is turning). This way I can take just the length byte and convert it into water flow (what I want to monitor).
But the problem is when I have more than one router, and I open the XCTU to see the incoming data, there are lots of packets coming everytime, not only in the moment that the sensor is turning.

What I want is: take only the bytes that matter to me: length (where I can take the data, the water flow) and source adress (I need to know where the data is coming from), and prints this. I´m trying to code in C++, using an Arduino UNO on the coordinator side, but I´m not being able to do this yet. Any ideia or clue? thanks
asked Sep 5, 2019 in RF Solutions and XBee by Enzo New to the Community (0 points)

Please log in or register to answer this question.

...