Home/Support/Support Forum/Initial time delay of data reaching the server
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Initial time delay of data reaching the server

0 votes
Hi,
I am using DIGI XBEE 3 CAT-1 module for sending data to server.
1)The following steps are followed in my code to send data.

+++ - Enter into Command Mode.
ATAN - Set APN.
ATIP 0 - To select UDP Mode.
ATRO 3 - To set Packetization Timeout.
ATDL 98.129.194.210 - To set destination Server IP.
ATDE C002 - To set destination Server Port.(49154)
ATC0 C002 - To receive data from Server.(49154)
ATAC - Apply the changes immediately.
ATCN - Exit Command Mode.
"hello" (Test data) - Data that transmits in Uart
2)Using above sequence I send data to server.

3)Whenever I am sending data to server the first data is reaching the server after 20-30 sec.

4)After the first data reaches the server if I send any data,it is reaching the server instantly.

Could you please help in solving this initial time delay of data reaching the server and please mention why it is happening.
asked Jul 12 in Digi Connect Cellular by prasath New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi,
I am unable to reproduce this issue with a VPN SIM on the latest firmware. What firmware version are you using?
answered Jul 12 by DigiFan23 Seasoned Professional (198 points)
...