Home/Support/Support Forum/cellular location

cellular location

0 votes
Hello Everyone,

I am working on XB3-C-A2-UT-001 module.
I want how can i get cellular location? i have refer the digi document link

www.digi.com/resources/documentation/Digidocs/90002258/#Containers/cont_at_cmd_descriptor.htm%3FTocPath%3DAT%2520commands%7CSystem%2520commands%7C_____0

i found one section i.e system commands,they mention about physical location command 'KL'.
I try this command if i can get the location but it is showing me error.

Currently my module is in transparent mode.

Could anyone help out what i am doing wrong?how can get cellular location?

Any help will greatly appreciated.

Regard,

Amit
asked Apr 29 in XBee Cellular by amitkumar New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The commands you linked to (KP, KC, KL) are settings on the XBee that allow you (the user) to _configure_ those values which are reported to Digi Remote Manager. XBee3 Cellular devices do not have a built-in GPS or anything similar, so there is no command to retrieve physical location information (like GPS) from the XBee.

Since you say the KL command is giving you an error, you are most likely running an older XBee3 Cellular firmware. Update to the 31011 firmware which was released last month - this firmware supports the KL command.

We also added the ATAS (Active Scan) command to the 31011 firmware version. This command will let you see information about the available cells ("cell towers") in your area. https://www.digi.com/resources/documentation/digidocs/90002253/Reference/r_cmd_AS.htm
answered May 9 by tckr Seasoned Professional (227 points)
...