Home/Support/Support Forum/Xbee3 802.15.4 - problem - I'm migrating to XBEE3.

Xbee3 802.15.4 - problem - I'm migrating to XBEE3.

0 votes
I already use the XBEE S1 and S2 module in my product, I'm migrating to XBEE3.
With the XBEE S1 / S2 modules, everything works fine.
In XBEE3 with the UART firmware 802.15.4, either it works for a while and stops, or when you turn it off and on again it stops working. Are there configurations that can solve this problem?
asked Jan 25 in RF Solutions and XBee by EduTruck New to the Community (0 points)

Please log in or register to answer this question.

4 Answers

0 votes
I'm having similar issue with XSTICK1 and XBEE3 with 802.15.4 firmware. No issues with S1 and XSTICK1
answered Mar 25 by meb New to the Community (1 point)
0 votes
Good morning,
I'm also having a problem with S3 module.
Our configuration is half duplex communication in a broadcast way of work.
It works for approx one hours then the XBEE 3 module seems to stop. Sometimes, even a hard reset is not enough to make it work again.
I have test my system with S2 modules.
Is there a solution to fix this problem ?
answered Apr 8 by francoiscadden New to the Community (2 points)
0 votes
Good morning,
I have tested my system with XBEE PRO V2 (still in 802.15.4 mode) and I don't have my previous problem anymore.
The XBEE PRO 3 in 802.15.4 mode really seems to be bugged.
answered Apr 9 by francoiscadden New to the Community (2 points)
0 votes
I am having the same trouble. No issues with the S1, but the XBee3 module locks up and I have to cycle the power to fix it. It seems to be something with the message format or timing. I can send much larger packets faster using a protocol analyzer and it works fine. I'm using the international version of the XBee3 and the Pro version of the S1.
answered 5 days ago by mhill New to the Community (1 point)
...