Home/Support/Support Forum/XBee - Monitoring a water flow sensor and control a water valve

XBee - Monitoring a water flow sensor and control a water valve

0 votes
I am not sure if a single remote Xbee2 (router) will be able to handle a water flow sensor's output (digital pulses pin (GPIO4) along with receiving a request to open/close a valve (data out high for 8 seconds) while the water flow valve is sending pulses? The Xbee's digital output pin (GPIO5) will be high operating a relay that will open/close the valve. Once opened/closed the valve does not need to be powered.

The above Xbee will communicate with an existing Xbee2 controller/Arduino that monitors the water level in my 10 rain barrels and gets activated once every five minutes.

Thanks,
Don
asked Nov 21 in RF Solutions and XBee by ElectronicsNut New to the Community (0 points)
edited Nov 21 by ElectronicsNut

Please log in or register to answer this question.

Contact a Digi expert and get started today! Contact Us
...