Home/Support/Support Forum/Zigbee HA - BINDING REQUEST from XBee S2C to CC2650STK

Zigbee HA - BINDING REQUEST from XBee S2C to CC2650STK

0 votes
Hi,

I am trying to perform the BIND operation from the XBee S2C module (zigbee network coordinator), sending this request to the CC2650STK sensor node.

The two modules are able to communicate correctly. For the BIND operation I tried first of all to execute the command through the module CC2531EMK following the steps indicated here:

https://sunmaysky.blogspot.com/2015/10/how-to-do-device-binding-from-ti-ztool.html

now I'm trying to make the Bind_req from the XBee S2C module following the instructions in the guide:

https://www.digi.com/resources/documentation/Digidocs/90002002/Content/Reference/r_zb_binding.htm?TocPath=Network%20commissioning%20and%20diagnostics%7C_____4


and then in the Zigbee specification, but it does not work. How could I solve?


Thanks
asked Sep 14 in RF Solutions and XBee by filippoN New to the Community (2 points)

Please log in or register to answer this question.

Contact a Digi expert and get started today! Contact Us
...