Home/Support/Support Forum/Max RF-data I can transmit using XBee 868 LP API mode - Digimesh

Max RF-data I can transmit using XBee 868 LP API mode - Digimesh

0 votes
The NP command in XCTU reports that the maximum payload size is 100 bytes for the XBee 868 LP.
When in API mode, I can send a package with a max RF-data of 95 bytes, and I receive a "succes" message.
When the RF-data is larger then 95 bytes, I don't get any response back.

What does a payload exist of, what is a payload?
Where in the documentation is stated what the maximum RF-data is that can be send?

When the XBee is in AT command mode I can send a much larger size RF-data (Tested 250 bytes, and is also ok). Is this packet split into smaller packets and re-assembled on the receiving side?
asked Jul 10 in DigiMesh Proprietary Mesh Networking by fredpeer New to the Community (0 points)

Please log in or register to answer this question.

Contact a Digi expert and get started today! Contact Us
...