Home/Support/Support Forum/Question about Policy Routing
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Question about Policy Routing

0 votes
I am looking for policy routing in the DIGI WR21.

Example:

The DIGI router is on range 192.168.10.0/24

Basically we need to return everything from range 192.168.20.0/24 if routet to the DIGI via the VPN tunnel- It is done today on a zyxel router with policy route “Route Traffic Through VPN”
I have not been able to find any information on this in the DIGI manual / config page.

Any leads to do this on the DIGI WR21


Thanks
martin
asked Jun 26, 2018 in Digi TransPort Cellular by martingjensen New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Hi

if you are using ipsec VPN on a WAN interface.
all traffic should be going to the wan interface when ipsec is enabled on the wan interface the trafic is tested to see if it matches the eroute network selector src/dst address ranges if it is and the vpn is up the router will sent the trafic over the vpn tunnel so policy based routing is not needed.

regards

James
answered Jun 27, 2018 by James.Wilson Veteran of the Digi Community (1,225 points)
...