Home/Support/Support Forum/WR44 Boot sequence leds meaning
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

WR44 Boot sequence leds meaning

0 votes
I have a WR44 which, upon boot, it follows this led sequence
Sec 0: LINK LED blinks about twice per second
Sec 2.5: LAN 1 LED (Laptop connected there) blinks very fast.
Sec 4: DSL LED lights GREEN
Sec 6.5: LINK and DSL LEDS go off.
Sec 9: All 4 LAN LEDs light green for 0.5 sec + DSL LED Lights Red for 1sec
Sec 10: LINK-SIM-ACT-Signal1-Signal2-Signal3 light green and immediately power off sequentially from left to right.

Then, a sec later, this all starts over again
Does anybody know what this sequence means and if it may be resolved? I tried flashing the router but it didn't help and obtained same result.
Thanks,
Daniel
asked Jun 26, 2018 in Digi TransPort by dmolina New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi

the flashwriter process should normally recover from this i would first try a different firmware image and if that does not work then do a full recovery

here is the link to full recovory process

http://ftp1.digi.com/support/utilities/WR44V2_Step_by_step_test.pdf

regards

James
answered Jun 27, 2018 by James.Wilson Veteran of the Digi Community (1,225 points)
...