Home/Support/Support Forum/Xbee Zigbee broadcasting problem

Xbee Zigbee broadcasting problem

0 votes
Hello, I have 2 Xbee Zigbee 2mW S2 connected to 2 Arduinos. I have configured the Addresses to both of them and I have managed to send messages (point-to-point) just fine. However when I use a third Arduino connected to a third Xbee Zigbee and I try to send from the other 2 Zigbees to the 3rd (using DH Destination Address High: 0, DL Destination Address Low: FFFF) the messages come corrupted in the 3rd Xbee, or half sentences and then comes the other half.

What is happening?
asked Jun 26, 2018 in ZigBee PRO Featureset (and legacy ZNet 2.5) by infinity New to the Community (0 points)

Please log in or register to answer this question.

...