Home/Support/Support Forum/Network Discovery ND data structure Zigbee 3 API mode

Network Discovery ND data structure Zigbee 3 API mode

0 votes
Issuing the ND command from the coordinator using the frame editor I receive two replies from remote devices.

I receive the following in the data, from Device1 and Device2:

05 36 00 13 A2 00 41 82 E3 9C 44 45 56 49 43 45 31 00 FF FE 01 00 C1 05 10 1E

AF DD 00 13 A2 00 41 82 E3 5B 44 45 56 49 43 45 32 00 FF FE 01 00 C1 05 10 1E

I can't see how this corresponds to the documentation which quotes:

PARENT_NETWORK ADDRESS<CR> (2 Bytes) (always 0xFFFE)
PARENT_NETWORK ADDRESS (2 Bytes) <CR>
DEVICE_TYPE<CR> (1 Byte: 0 = Coordinator, 1 = Router, 2 = End Device)
STATUS<CR> (1 Byte: Reserved)
PROFILE_ID<CR> (2 Bytes)
MANUFACTURER_ID<CR> (2 Bytes)
<CR>
asked Jun 26, 2018 in XBee3 ZigBee by rowifi New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
This has been answered by Digi
It appears like some information is gone missing from our documentation. I'll get it corrected.

Below is correct format for ND command's response:

MY<CR>
SH<CR>
SL<CR>
NI<CR> (Variable length)
PARENT_NETWORK ADDRESS (2 Bytes)<CR>
DEVICE_TYPE<CR> (1 Byte: 0=Coord, 1=Router, 2=End Device)
STATUS<CR> (1 Byte: Reserved)
PROFILE_ID<CR> (2 Bytes)
MANUFACTURER_ID<CR> (2 Bytes)
answered Jun 28, 2018 by rowifi New to the Community (3 points)
...