Home/Support/Support Forum/Xbee S2 with DHT22

Xbee S2 with DHT22

0 votes
Hi Folks,

I have just started experimenting with Xbee radios and I have hit the wall. Here, is my project story.

I am trying to receive Temperature and Humidity data from remote
- XBee-S2 (Router AT)
- Connected with DHT22 (on pin AD0)
- For level shifting I have connected 1k resistor from PIN-2 to PIN-1

Coordinator:
- Arduino UNO
- XBee S2 (Setup as Coordinator API)
- Pins connected
XBee TX to Arduino RX
XBee RX to Arduino TX

Code on receiver side (simple)

void setup()
{
Serial.begin(9600);
}
void loop()
{
if (Serial.available()>=21){
for(int i=0;i<26;i++){
Serial.print(Serial.read(),HEX);
Serial.print("-");
}
Serial.print(",");
Serial.println();
}
}

The output that I receive on Ardunio IDE Serial Monitor is :
7E-0-12-92-0-13-A2-0-40-F9-69-94-A-4F-1-1-0-1-0-0-1-FFFFFFFF-FFFFFFFF-25-FFFFFFFF-FFFFFFFF-,
7E-0-12-92-0-13-A2-0-40-F9-69-94-A-4F-1-1-0-1-0-0-1-FFFFFFFF-FFFFFFFF-25-FFFFFFFF-FFFFFFFF-,
7E-0-12-92-0-13-A2-0-40-F9-69-94-A-4F-1-1-0-1-0-0-1-FFFFFFFF-FFFFFFFF-25-FFFFFFFF-FFFFFFFF-,

Questions:
1. The first 20 bytes, they are correct and I understood what they are
2. From 21st byte, I am not sure what and why they are as displayed

Appreciate your help and guidance.

- Vijay
asked May 31, 2018 in ZigBee PRO Featureset (and legacy ZNet 2.5) by VijayKRao New to the Community (0 points)

Please log in or register to answer this question.

...