Home/Support/Support Forum/how to check if the command is going to the serial port of the digi one sp ?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

how to check if the command is going to the serial port of the digi one sp ?

0 votes
in the Digi One SP i am trying to send a command to a Arbiter GPS clock . but it seems that the command is not being . while checking the sending end which is our scada server the command is going . we are doubting the command is not going after the digi one SP terminal server so how to check ?


we had tried to telnet to that particular port 2101 and was able to see some data from the clock so how to make sure taht the command which is send from the sending end is going till the clock ?
asked May 24, 2018 in Console Servers by arunsreenair New to the Community (0 points)

Please log in or register to answer this question.

...