Home/Support/Support Forum/Xbee SX 868 questions

Xbee SX 868 questions

0 votes
Hello,

Before purchasing the Xbee SX 868 module I want to ask you some questions.
Here is my project :

I have on the first hand 3*3 switches. I want to connect all of them with an Xbee SX 868 to get their states. On the other hand, they will be 3 boards with 3 relays and one Xbee SX 868 on each board.
What I want to do is that when a switch is ON or OFF, the Xbee will send an order to the corresponding Xbee which is connected to the corresponding relay.
For example :

Xbee A (coordinator) :
Switche 1B = OFF
Switche 2B = OFF
Switche 3B = ON

Switche 1C = ON
Switche 2C = ON
Switche 3C = ON

Switche 1D = OFF
Switche 2D = OFF
Switche 3D = OFF

Xbee B (end device) :
relay 1 = OFF
relay 2 = OFF
relay 3 = ON

Xbee C (end device) :
relay 1 = ON
relay 2 = ON
relay 3 = ON

Xbee D (end device) :
relay 1 = OFF
relay 2 = OFF
relay 3 = OFF


I want this communication to be secured with AES 128 encryption and ACK.

I am aware of I/O line passing, but I am wondering if it's possible to do such thing on a network with the api mode?

I am also wondering if it is necessary to use a microcontroller like an Arduino to do that? Or is it enough to use only the Xbee with line passing ?

Is it mandatory to have a pc attached to one xbee on the network or not? Because all of the examples showing Xbee network in api mode are using a PC attached to the coordinator device.

Thank you in advance...
I look forward to hearing from you soon.

Pierre OLIVA.
asked May 16 in RF Solutions and XBee by pierre33 New to the Community (4 points)

Please log in or register to answer this question.

Contact a Digi expert and get started today! Contact Us
...