Home/Support/Support Forum/Using Serial Port A in regular operation on the RCM6700?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Using Serial Port A in regular operation on the RCM6700?

+1 vote
Hello,
I'm attempting to configure the RCM 6000's programming port (TX/RX PC6, PC7) for use as a regular serial port. I am using the serial port in the same manner I use all my other serial ports, following the same process for initialization, reading and writing and in fact already have my code working on the prototype board (using the C serial port in that case). However, moving the same code to the production board and using serial port A does not work. The board is in run mode so the bootloader should not be running in the background, are there any additional definitions needed to get Serial Port A to work as a normal serial port?
asked May 14 in Rabbit Software by nj New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Have you tried any simple sample programs? I was able to configure Samples\reset_demo.c to use serial port A and run it on the prototype board by removing the first jumper of JP1.

Make sure you aren't defining STDIO_DEBUG_SERIAL in your project, since that might be locking up the serial port for printf() output.
answered May 14 by TomCollins Veteran of the Digi Community (1,051 points)
Contact a Digi expert and get started today! Contact Us
...