Home/Support/Support Forum/router loosing connection until it is flashed

router loosing connection until it is flashed

0 votes
hope I got the right forum!

I have 2 xbee s2c modules, when they have the same pan id they connect ok.
but if I change the pan id on the coordinator they no longer pair up (which is ok!)

my problem is that when i change the pan id back in the coordinator it will no longer pair up to the router, in fact .. after this happens the router acts buggy , it no longer responds on the pan, and even struggles connecting to serial on xctu (i need to hit reset on the module every time i read/write with xctu on serial) ... this problem goes on until flash the device firmware and reprogram it ... then it starts to pair with the coordinator again... and work properly on serial again too...

can someone tell me why this happens!!>>???
can someone tell me why this happens!!>>???
asked Mar 19, 2018 in DigiMesh Proprietary Mesh Networking by DrDoggy New to the Community (0 points)

Please log in or register to answer this question.

...