Home/Support/Support Forum/RCM4300 - No rabbit processor detected
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

RCM4300 - No rabbit processor detected

0 votes
Trying to use RCM4300. Connected pin 1 to +3.3V. Connected Pin 2 and 50 to GND.
Connected the USB PROG Cable P/N: 20-101-1183 to the board.
Trying to run a sample program. I get the error message

"While Sending Cold Loader. No Rabbit Processor detected"

Any ideas?

Thanks

Bobby
asked Feb 16, 2018 in Rabbit Software by Bobby1 New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
Make sure you use the "PROG" connector and not the "DIAG" connector at the end of the cable. The red stripe should be close to the edge of the board.
answered Feb 16, 2018 by TomCollins Veteran of the Digi Community (1,327 points)
...