Home/Support/Support Forum/Rf communication between 3 microcontrollers using Xbee s2(XB24)

Rf communication between 3 microcontrollers using Xbee s2(XB24)

0 votes
Hi all!

I need to know if there any special configuration i need to do exept the networking ones
so that i could send data from one microcontroller to the other using UART.I am planning to use PIC type microcontollers and logic gates so that the 5v is converted to 3.3v.

asked Feb 6, 2018 in XCTU by xbeeuser33 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
just make sure that one is a coordinator and that the other two have associated with that coordinator. Other than that, the default configuration of the XBee S2 Zigbee modules is Point to multi-point with the router and end devices pointing to the coordinator, and the coordinator is in Broadcast to all other nodes at 900 baud, 8 data bits, no parity and 1 stop bit using transparent mode. That means, Data in = data out.
answered Feb 6, 2018 by mvut Veteran of the Digi Community (11,300 points)