Home/Support/Support Forum/AT Commands successful, but command values reset to previous when Xbee unplugged

AT Commands successful, but command values reset to previous when Xbee unplugged

0 votes
For days I thought my AT commands were failing because when I would plug the Xbee into XCTU, the values would not show as changed.

I monitored frames in and out of my arduino and confirmed that everything was being sent and received exactly as it is in XCTU. Then I added an LED to the DIO pin I was controlling and verified that the pin was indeed changing.

So if the arduino is accomplishing the same thing as XCTU, why is the new value not stored on the Xbee?
asked Sep 25, 2017 in IEEE 802.15.4 by D_MK New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

+1 vote
 
Best answer
If you want a value to remain after a power cycle, you must issue the Write command.
answered Sep 25, 2017 by mvut Veteran of the Digi Community (11,298 points)
selected Sep 25, 2017 by D_MK
...