Home/Support/Support Forum/IAS Zone Cluster Reporting at Fixed Interval Time

IAS Zone Cluster Reporting at Fixed Interval Time

0 votes
I have some IAS Zone motion sensor and door sensor but sometime they can go for months without triggering. How can I get them to report at fixed interval time so I would know that they are still working?e.g. hourly, daily
I have checked from Zigbee Cluster Library that under the cluster ID (0x0500 - IAS Zone Cluster), there is only one command ID that I can send from my hub which is (0x00 - Zone Enroll Response). Is there a way to make the sensors response back when I send them something?
asked Sep 11, 2017 in RF Solutions and XBee by wimpetus New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
If the standard does not provide any additional commands, then the answer would be no. But I would check with the manufacture of the Sensor to verify that.
answered Sep 11, 2017 by mvut Veteran of the Digi Community (13,104 points)
selected Sep 14, 2017 by wimpetus
...