Home/Support/Support Forum/What's going wrong that requires a reset when updating firmware?

What's going wrong that requires a reset when updating firmware?

0 votes
When I try to update firmware such as when I switch an Xbee from AT to API I am often getting the pop-up asking me to do a reset. Why does this happen.
asked Aug 22, 2017 in RF Solutions and XBee by rfgabriel New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The module is not able to enter command mode or bootloader mode for any one of a number of reasons. The reset allows for a backdoor option to be used which is sometimes needed.
answered Aug 22, 2017 by mvut Veteran of the Digi Community (12,767 points)
Where can the code for the backdoor be found?
...