Home/Support/Support Forum/Set child poll timeout in co-ordinator XBee Gateway

Set child poll timeout in co-ordinator XBee Gateway

0 votes
I am trying to set a child poll timeout of an hour so if I have set SN=60 and SP=2000 I believe this should give me a timeout of 3 x 20sec x 60 = 3600 secs ie one hour. To test this I associate an end device and observe NC getting decremented (20->19). I then turn off the end device and monitor NC. After 250 seconds it increments back to 20. This is causing me a problem as it is forcing a lengthy re-association.
Can anyone tell me how to set the timeout to an hour?
The firmware on both the xbee modules is 405F
asked Aug 4, 2017 in RF Solutions and XBee by mike.mccusker New to the Community (9 points)

Please log in or register to answer this question.

1 Answer

0 votes
What is your SO set to? It should be set to 0x10.
answered Aug 11, 2017 by mvut Veteran of the Digi Community (11,302 points)
...