I‘m trying to connect the XBP9B-XCST-022 Xbee module via the grove development board to my computer to configure the module with the XCTU software. The problem is, that I’m getting a lot of junk-data displayed as parameter settings when I load the settings into XCTU.
Might I’m using the wrong/incompatible board? If this is so, would you recommend me a basic board for testing the device. I already adapted the COM-port setting as shown in http://knowledge.digi.com/articles/Knowledge_Base_Article/Optimizing-USB-to-serial-port-settings/?q=optimizing+usb+drivers&l=en_US&fs=Search&pn=1 .
Im using windows 10 and the latest version of XCTU.
Thank you very much in advance for helping me.