Home/Support/Support Forum/PWM and digital output

PWM and digital output

0 votes
Hi !


I have a little problem again

When I activate a PWM output, I have my led that turns on. Then when I want to turn on or off a led that is on a digital output, in both cases my led that is on my pwm goes out. Do you know why ?

I work in API mode, with a coordinator and an end device

Thank you and have a nice day ! :D
asked Apr 28, 2017 in RF Solutions and XBee by Tim Grasset New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
What line is the PWM connected to and which module are you working with?
answered May 1, 2017 by mvut Veteran of the Digi Community (11,302 points)
The LEDs are located on the "End device"


I have leds on the following pin: PWM0 / PWM1 / D0 / D1
Which XBee modules are you working with and what firmware version is installed?
I use Xbee pro s1,  Firmware version:10e6
Sounds like you are using the wrong function in the DIO sample section. Try using a Sample rate instead of a change detect. Also update your firmware to 10EF.
...