Home/Support/Support Forum/how do you set an xbee to send a DI state change out its own uart

how do you set an xbee to send a DI state change out its own uart

0 votes
I have a two xbee network with one of the xbees plugged into rs232 to xctu. The xbee NOT plugged to the xctu WILL show a DI state change on XCTU. I cannot get the xbee plugged into the Xctu to show a state change. Please give guidance.
asked Sep 7, 2016 in RF Solutions and XBee by Dare New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
The local radio is not suppose to show a change of state out of its UART.
answered Sep 8, 2016 by mvut Veteran of the Digi Community (14,294 points)
...