Home/Support/Support Forum/How to set xbee master to send a state change to rs232

How to set xbee master to send a state change to rs232

0 votes
Scenario: Xbee Master connected to XCTU via RS232 and
Xbee Slave communicates to Master via RF.
Xbee Slave correctly communicates a state change to the Master and then is read via XCTU. However, I cannont seem to get a state change on the Master to show up on XCTU. How is the profile set on the master to send a state change to RS232?
asked Sep 6, 2016 in DigiMesh Proprietary Mesh Networking by Dare New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
which XBee product are you referring to and what state change are you referring to?
answered Sep 7, 2016 by mvut Veteran of the Digi Community (14,294 points)
0 votes
Xbee Pro S1
D3 set to 3
IC command for D3
answered Sep 7, 2016 by Dare New to the Community (1 point)
...