Home/Support/Support Forum/How to use "Create Source Route (0x21)"

How to use "Create Source Route (0x21)"

0 votes
Hi,I want to know how to use the "Create Source Route (frame type : 0x21)".

Currently, I have followed this document.

http://www.digi.com/wiki/developer/index.php/Large_ZigBee_Networks_and_Source_Routing


But this document does not mention
how to extract( or read )the recorded source route.


This is my setting of "Create Source Route Frame".

Start delimiter : 7E
Length : 00 0E
Frame type : 21
Frame ID : 01
64 bit dest address : 00 13 A2 00 40 E2 D6 99
16 bit dest address : FF FE
Route com ...d options : 00
Num of addresses : 00
Addresses : 00 00
Checksum : 9B


And after send the "Create Source Route Frame"

i send a Transmit Request Frame( frame type : 0x10 ).
and i can receive Transmit Status ( frame type : 0x8B ).

But this "Transmit Status" does not include
Source Route.
asked Aug 22, 2016 in RF Solutions and XBee by SungPum New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Transmit status is not expected to return transmission route in it. You have to believe that it must have taken route provided in 0x21 frame.

If you really want to check route then use ZDO API frames to fetch Routing table of XBee and check it out.
answered Aug 24, 2016 by asgm Veteran of the Digi Community (1,498 points)
...