How will I receive the Voltage Supply Monitoring values?

In the XBee AT commands specification it is stated the following:

(...)The voltage supply threshold is set with the V+ command. If the measured supply voltage falls below or equal to this threshold, the supply voltage will be included in the IO sample set. (...)

I'm not sure of it's meaning. Does it mean that if it goes below the define threshold, every IO Sample transmitted will also include the voltage value?

If that's true, to which pin will it be associated?
And, although, the following scenario may not make sense, what if a specific node only transmits a IO Sample once / month? Does that mean that in the meanwhile no "Voltage Supply" value is transmitted?

Thanks for clarifying.

Carlos

asked Aug 17, 2016 in Miscellaneous Hardware and Software by cvicente New to the Community (6 points)

Please log in or register to answer this question.

1 Answer

Yes that is correct. It will be sent out with an IO sample packet not associated to a specific pin. That is assuming that your receiving radio is in API mode.

answered Aug 18, 2016 by mvut Veteran of the Digi Community (12,353 points)

Hi mvut,

Thanks for answering. And I assume that it will only be sent out included in a already existent IO Sample, otherwise it won't be sent out at all, correct?

commented Aug 20, 2016 by cvicente New to the Community (6 points)

No, you don't need to have the IO function enabled to get this data. You only need to have the battery voltage function enabled.

commented Aug 22, 2016 by mvut Veteran of the Digi Community (12,353 points)

But I imagine that at least it will use the IO frequency parameter, unless there is a pre-defined one for sending this data.

commented Aug 25, 2016 by cvicente New to the Community (6 points)

What is the exact product you are referring to?

commented Aug 26, 2016 by mvut Veteran of the Digi Community (12,353 points)

XBee S2B not the Pro version, although it applies the same concept in terms of monitoring the input voltage.

Once again, what is said in the documentation is:

(...)The voltage supply threshold is set with the V+ command. If the measured supply voltage falls below or equal to this threshold, the supply voltage will be included in the IO sample set. (...)

So, it's not clear at all. Actually when it says "included" it seems to mean, that no particular IO Sample will be created to send that information, but it will be "included" in any other IO Sample frame that is already sent from that XBee.

On the other hand, if it actually sends an IO Sample specifically for that information, the question is, with which frequency.

commented Aug 26, 2016 by cvicente New to the Community (6 points)

I am sorry but I don't know. That is something that you may be better off simply testing to see what it does.