Home/Support/Support Forum/How to use "Route Request Command"

How to use "Route Request Command"

0 votes
Could you tell me How to use "Route Request Command"?
I konw the general format of the Route Request Command from this document, page …

http://home.deib.polimi.it/cesana/teaching/IoT/papers/ZigBee/ZigBeeSpec.pdf
page 343/604

Octets: 1 | 1 | 2 | 1 | 0/8
Command | Route request | Destination | Path cost | Destination
options | identifier | address | | IEEE Address
NWK command payload
Route Request Command Frame Format



But i don't know how to send it using XCTU,
since I could not find any thing related to it in X-CTU

Could you tell me how to send it using X-CTU?
In addition, could you tell me how to send it in API mode?
asked Aug 16, 2016 in RF Solutions and XBee by SungPum New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Read the product manual for the exact xbee module you are working with. You will find that the ability to view the rout is part of the radios firmware and documented.
answered Aug 18, 2016 by mvut Veteran of the Digi Community (12,010 points)
...