Home/Support/Support Forum/Xbee Pro S2B Bypass Mode

Xbee Pro S2B Bypass Mode

0 votes
Hi,

I have a net with Xbee's Pro S2 and i want to add a Xbee pro S2B. I read that to configure a Xbee Pro S2B i need acces in the bypass mode but i don´t know like do it.

thanks
asked Aug 16, 2016 in XBee Programmable Development by jacobo1991 New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
No, you don't. Bypass mode is ONLY used on the Programmable versions of the product. A standard S2B or XBee ZB PRO module acts just like the Non PRO versions.
answered Aug 18, 2016 by mvut Veteran of the Digi Community (12,001 points)
how can i to add the S2B to the net configured with Xbee's PRO S2 ZB
What is the full part number of the module you are trying to add to the network?
as I have seen , I need Codewarrior and Xbee sdk .
what do I have to do with them and how?
I can tell and you can do if the module is a programmable module or not.  that is why I ask what the part number is.
The part number is XBP24BZ7WITB-003 revL
That is the Programmable module (You added an extra - in it between the B and the 003).  To use this one, you will need to write an application and port it over via a BDM programmer before you will be able to talk with it on a regular basis. That is depending on what you put on the Freescale processors for the application.
could you explain or give me a link to an example or something to orient me

Thanks
I am afraid that all of the examples for this product are found within the XBee Programmable SDK and Code warrior.
...