Home/Support/Support Forum/How can I configure CE (Coordinator Enable) to Enabled [1] or Disabled [0] via AT Commands?

How can I configure CE (Coordinator Enable) to Enabled [1] or Disabled [0] via AT Commands?

0 votes
I own a pair of XBEE S2C.

How can I configure CE (Coordinator Enable) to Enabled [1] or Disabled [0] via AT Commands?

My requirement is to configure the XBee Module via controller.
asked Aug 16, 2016 in XBee Programmable Development by ippatil New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
For Enable coordinator AT command is: ATCE 1
for read the CE parameter :ATWR
for Disable coordinator AT command is: ATCE 0
answered Aug 17, 2016 by csreddy Seasoned Professional (192 points)
...