Home/Support/Support Forum/Problem with button/led example

Problem with button/led example

0 votes
I have followed the example for the button/led... I have two xbee S1 modules. When I press the button the led lights up, but it flashes instead of staying solid... any suggestions?

I am powering both from the same 2xAA and used XCTU to reset to defaults and change the required fields following the examples.
asked Jul 12, 2016 in IEEE 802.15.4 by j9fab New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
open serial port on module with LED and observe if its flooded with many API frames.

I am suspecting this to be a result of bad hardware (button).
answered Jul 15, 2016 by asgm Veteran of the Digi Community (1,427 points)
...