Home/Support/Support Forum/how to make C -R -E or C-R-R-E network with XBEE S2

how to make C -R -E or C-R-R-E network with XBEE S2

0 votes
Hi

I am using the XBee S2 devices with the model no
XB24-Z7WIT-004.

I have 4 such devices with the adapter board .
I want to make a network as Coordinator(C) - Router(R) - End Device (E). thats is End device will send the data to the router and Router will forward that data to the Coordinator .

I have used the XCTU to configure the dec=vice and given the same PAN ID but the devices directly connect to the Coordinator .

then I have put the address of C in Router DH and DL and in the same way DH and DL of end device was set to router address . but this only sending the data to the router only . router is not forwarding the data to coordinator which it received from the end device .

Let me know what to do for establishing the network . and moreover How I can measure the throughput of the whole network .
asked May 24, 2016 in IEEE 802.15.4 by manishrpv New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

+1 vote
coordinator router end device

SH1=XXXX SH2=XXXX SH3=XXXX
SL1=XXXX SL2=XXXX SL3=XXXX
DH1=0 DH2=SH1 DH3=SH1
DL1=FFFF DL2=SL1 DL3=SL1

try this one it will working fine
answered May 26, 2016 by csreddy Seasoned Professional (194 points)
edited May 26, 2016 by csreddy
working with docklight
...