Home/Support/Support Forum/Wifi S6B not working with configuration download

Wifi S6B not working with configuration download

0 votes
I have just bought two back-up XBee S6B modules. I have updated the firmware from 2024 to 2026. I then wrote a previously saved config file from a working XBEE of the same type. Scrolling through all the parameters they are all identical. The module is set up as follows: AH 1, CE 2, NS 192.168.1.1, DL 192.168.1.14, NI Creater, GW 192.68.1.1, MK 255.255.255.0, MY 192.168.1.13, BD 7. Only one of these three modules is used at once. It is meant to communicate with another XBEE with the following parameters: NI Joiner, AH 2, DL 192.168.1.13 and MY 192.168.1.14. Despite the fact that I'm using a working config file the set-up is not working. Any ideas what I could be doing wrong?
asked May 5, 2016 in IEEE 802.11 (Wi-Fi) by snowsparky New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to have the Joiner re-scan and Join the New creator.
answered May 9, 2016 by mvut Veteran of the Digi Community (13,104 points)
What do you mean by re-scan? Doesn't it automatically re-scan when you switch it on? At the moment I switch on the creator and then switch on the joiner. I'm obviously missing something.
I am missing something.  Did you create a new profile for the New 2026 firmware version or are you still using the PRO file you created for the 2024 version when you write the settings?
...