Home/Support/Support Forum/Set Xbee Pro S2B in No Sleep mode

Set Xbee Pro S2B in No Sleep mode

0 votes
hi every body.
i have 4 Xbee Pro module . i set one of the as coordinator AT and 3 of them as End Point AT

I set the DL of Coordinator to 0xFFFF to broadcast, but there is a problem in receiver modules . the data that is receiving is not realtime. there is random delay between each receive in each module and suddenly all the packet receives at same time . i thought that it might because of sleep mode in my End Point devices . each of them has sleep mode of "Cyclic Sleep[4]" when i want to change it to No Sleep[0] it again sets to Cyclic Sleep .

would it be the cause of problem ?? if yes how can i set sleep mode to No Sleep ??
asked May 5, 2016 in RF Solutions and XBee by mohamad New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Set your End devices as routers and you should see your issues clear up.
answered May 9, 2016 by mvut Veteran of the Digi Community (11,966 points)
...