Home/Support/Support Forum/Configuring End Device at XBee S2C

Configuring End Device at XBee S2C

0 votes
I am using XCTU 6.3 with XBee S2C

I was successfully able to configure coordinator and 2 routers with XBee with below configuration


Coordinator
PANID=2016
DH=0
DL=FFFF
Coordinator Enable=1

Router 1 and 2
PANID=2016
DH=0
DL=0
Coordinator Enable=0

Now I want to add an ED in this mesh network. How is the config of an ED different from a Router? Is it setting up SP and SN (with the same PANID and Coordinator Enable=0)? Anything else?
asked Apr 21, 2016 in RF Solutions and XBee by lilyhack New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
Close, you need to enable the sleep command as well (SM).
answered Apr 21, 2016 by mvut Veteran of the Digi Community (11,302 points)
Force the end device connect to one of the router.
...