Home/Support/Support Forum/ATMY (or ATAM) equivalent for XBEE 900 HP

ATMY (or ATAM) equivalent for XBEE 900 HP

0 votes
Hello,

I was using the XSTREAM RF modem in previous projects.
Now, for a new project, I'm using the XBEE 900 HP in transparent mode.

I would like to know what is the equivalent of the ATMY (or ATAM) command on the XBEE 900 HP.

How can I set the source address of the module ? (For example, I was used to assign the ATMY of the base station to 0)


I was thinking to use ATSH/ATSL but these parameters are read only on the XBEE 900 HP.


Any suggestion ?
asked Apr 15, 2016 in XBee Programmable Development by ssinfod New to the Community (6 points)
edited Apr 15, 2016 by ssinfod

Please log in or register to answer this question.

1 Answer

0 votes
You are using the wrong firmware for the Xstream replacement. Try loading the XBP9B-XC firmware on your modules. You will then see all of the commands you are looking for. You will also notice that the module will then be able to talk with your existing X09-009 and X09-019 radios in the field.
answered Apr 18, 2016 by mvut Veteran of the Digi Community (11,298 points)
...