Home/Support/Support Forum/UART communication fails between NI myRIO and XBEE PRO S3B

UART communication fails between NI myRIO and XBEE PRO S3B

0 votes
I am trying to connect an XBee Pro S3B to an NI myRIO, via a UART visa connection. I have all of the serial settings the same, such as Baud rate, parity, stop bits, and data bits. But every time I try to sent anything to the XBee or read from the XBee i get an error that the serial communication was unsuccessful.
asked Mar 22, 2016 in RF Solutions and XBee by APT008 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Are you able to communicate between the two xbee modules when mounted on interface boards and your PC?
answered Mar 22, 2016 by mvut Veteran of the Digi Community (11,302 points)
...