Home/Support/Support Forum/analog signal transmission when connection lost

analog signal transmission when connection lost

0 votes
Hey guys,

I need some help: I'm transmitting 2 analogues (coded) signals with an xbee series 1. I have to power the transmitter with a batterie. When the connection between the xbees is lost (due empty batterie for example), the receiving xbee gives out a signal, which must'nt be in my case. Is there any possibility to configure the receiver that there is no signal output if connection lost?

thanks guys,
chris
asked Mar 21, 2016 in IEEE 802.15.4 by atsteich New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
What you are saying is not possible. The XBee modules do not have the capability of sending data out the UART unless it was received over the RF port from another XBee module.
answered Mar 22, 2016 by mvut Veteran of the Digi Community (11,300 points)
...