Home/Support/Support Forum/Digi One SP on a network
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Digi One SP on a network

0 votes
Hello.
I have 6 Digi One SP units. All 6 get onto the network (ie, ethernet port light is green) when plugged into an ethernet port of a laptop or a netgear switch. None of them get onto the network (no lights on the ethernet jack) when plugged into a cisco managed switch. The cable is fine, as I used the same one for both switches. The switch is fine, as I can plug a laptop in and get on the network right away. I even tried an older SP One with an older version of firmware and it reacted the same way.
The switch port:
switchport access vlan 40
switchport mode access
speed 1000
duplex full

Any suggestions ?

Thank you...
asked Mar 10, 2016 in Serial Servers by JohnP New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
I would try setting the network switch to 100 mb full or auto auto.

Can you test the units on a standard 10/100 mb router?
answered Mar 10, 2016 by halovapor Veteran of the Digi Community (918 points)
selected Mar 14, 2016 by JohnP
Apologies for the delay. The person making the change on the switch was a few time zones away. 100/Full worked and the Digi One is now on the network.
...