Home/Support/Support Forum/I configured one ZigBee as coordinator AT and another as Router/ End device Digital I/O.

I configured one ZigBee as coordinator AT and another as Router/ End device Digital I/O.

0 votes
But router is now not recognising,and how to reset ZigBee default values?
asked Feb 23, 2016 in IEEE 802.15.4 by YATHISH New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You are going to need to use the recovery function in XCTU to load the Router/End device AT firmware on the module if you want to have UART access. The Code you loaded is designed and meant for the DIO adapter product only.
answered Feb 24, 2016 by mvut Veteran of the Digi Community (11,300 points)
Module is not detecting in Xctu
...