What pin required to config 9xtend oem module using TTL?

Question

I am not sure if this is the right place for my question,

I have OEM RF MODULE 9xTend 900 Mhz,

I want to connect it to XCTU Software for configuration,

I connect Vcc ,GND ,DI, DO,

What are other pins need to be connected?

Regards,

Answer 1

You need to connect the Shut down pin as well. But you need to connect all of these via a level shiftier in order to connect them to a PC.

Comments

thanks for replay ,

sorry but what you mean by "a level shiftier" ?

---

A level shifter is a circuit that shifts the one voltage to another. In this case a 5V TTL to an RS232 level.

If you are not sure what one is, I would strongly urge you to purchase an XTIB-R interface board to mount the radio on and connect to your PC or other RS232 or 485 devices.

---

I connect the TTL VCC to the pin 2 VCC and to pin 7 shut down ,
 Dose that fine ? Or it need specific voltage?

How I know that the module is ON ?

coz when I connect to XCTU It couldn't find the module and I get the Action required dialog ,

---

That is not sufficient in order to connect the Xtend OEM module to the PC.  YOU MUST connect it to a board such as the XTIB interface board that provides the proper voltages, currents and level shifters to keep from Damaging the 5V TTL level module.

---

Mvut ,

I know it is not sufficient way ,

but now I don't have that board , and I couldn't get it easily,

my friends do it without that board ,

Dose the laptop TTL output voltage good ?  
what about if I use regulator 5 v ?

---

Laptops don't output TTL levels.  They output RS232 levels on the RS232 port.  Now if you get a USB to TTL level cable, then you might be able to get something working.

---

thanks MVUT , It works for me using usb -to - TTL cable , I am able now to configure it ..

thanks again .