I'm a newbie in Xbee so, I should like to apologies if my question is still solve. However, I'm 4 hour in your forum and in google without any success.
Anyway, my story is the following one:
I'm involved in a challenging research project that would, roughly speaking, allows to implements some distributed optimization algorithms based on consensus by employing arduinos and xbee for the communication setup.
My equipement consist into
- 2 xbee modules XB24-AWI 001-revB (2008-05-01-17)
- 1 dfrobot xbee usb adapter
- 2 arduinos
- 2 xbee shields for arduino
Note, in the future the network should have at least 5 or more nodes.
Anyway, I know that, the first step whenever we are working with Xbee is to configure my two modules with XCT by employing my usb-adapter.
All right? I think yes, but my problem is that when I try to "discover" my module from XCT, I can see only one of them....What can i do to see it?
Hereinafter, some further information:
-during the scanning RSSD and the TX leds blink whereas the RX not...
-My XCTU version is the 6.3.0 and I made all the available updates of the software
-I'm working on Windows 10
-I've also tried the Xbee-recovery from xctu without succes
Honestly I've no idea about what to do...I'm starting to think that I should reset the module that does not respond by follwoing this guide https://www.youtube.com/watch?v=KamcI1wjNQ8
Since I'm not an expert on Xbee I would like to hear yours opinion.
Thanks guys, I looking forward for your answers.