Home/Support/Support Forum/Failed to save configuration Digi One SP
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Failed to save configuration Digi One SP

0 votes
While trying to configure a Digi One SP, at the stage where you've entered the IP/Subnet/Gateway information and upload it to the unit I get an error saying "Failed to save configuration"

The report says "Waiting for device... FAILED"

What could be the reason for this? I am directly plugged in to the unit, I find the unit in Digi Device Discovery and I can enter all the info.
asked Feb 3, 2016 in Serial Servers by liland New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Make sure your PC is on the same network subnet as what you are trying to assign to the Digi unit. Also, make sure other network interfaces are not active on the PC (i.e. WiFi).
answered Feb 3, 2016 by userid0 Veteran of the Digi Community (2,158 points)
0 votes
As a workaround, you could use the Digi Device Discovery Utility instead to configure the IP settings, and then manually perform the rest of the configuration (for example, if you will be using the Digi RealPort driver, install that afterwards) separately.
answered Feb 3, 2016 by jeremym Veteran of the Digi Community (1,673 points)
...