Home/Support/Support Forum/How to issue a network leave command?

How to issue a network leave command?

0 votes
I read in the XBee PRO user manual that a router can leave a network by issuing a network leave command. How do i issue it? I don't find it anywhere.
If i use ATNR0 (or CB with parameter set to 4) to force a router to leave a network, will it hurt the XBee?
asked Jan 31, 2016 in ZigBee PRO Featureset (and legacy ZNet 2.5) by resindraburiza New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
ATNR0 will cause network to reset (leave and join again) and it will not hurt XBee.

You can issue ATRE to restore module parameters to default values, including ID and SC. The device attempts to join a network based on its ID and SC settings.
answered Feb 1, 2016 by asgm Veteran of the Digi Community (1,498 points)
...